Primer Lugar +Negocios
1.The SunFounder 250 quadcopter is tailored for hobbyists and beginners for FPV flying.
2. This aircraft is light in structure with its propeller blades featuring high strength, explosive-resistant and small wind resistance due to their smooth design.
3.It runs the firmware of CC3D flight controller, working with the EMAX Simon 12A brushless motor and ESC.
4.Weight: 519g ; Duration of flight: 7 minutes；Working voltage: 11.1V
5.CC3D software debugging guide and the assembling videos of the aircraft are provided for you. For more information, refer to our wiki.
The realization of FPV flying starts from having a SunFounder 250 aircraft. The SunFounder 250 Quadcopter is tailored for the hobbyists for FPV flying. It features stability, flexibility and activity. You can realize a stable flight in a high or low altitude or in a forest with the SunFounder 250. The skid landing damping sponge tubes bound onto the motors help stablize the flight and protect the frame through increasing the buffer between the frame and the land when the aircraft is landing.
It runs the OpenPilot firmware of the flight controller firmware and the 12A EMAX brushless electronic speed controller. This kit is designed to meet the hobbyists’ higher requirement of flying the aircraft. You can realize a stable flight in a small space or a rapid 3D flight based on your own configuration and parameter setting.
The SunFoundere 250 quadcopter kit uses the 6040 propellers blades. If you want to experience a violent 3D flight, the 5045 propeller blades are needed. For them, you are recommended to refer to THIS.
For the camera kit, you are recommended to refer to THIS.
For the FPV TFT LCD, you are recommended to refer to THIS.
For the FPV Image Transceiver Kit, you are recommended to refer to THIS.
The Remote Controller is available HERE.
Quadcopter Frame x 1(set)
EMAX CW /CCW Motor x 4
Balance Charger x 1
Battery Indicator x 1
Power Adapter x 1
EAMX WESC x 4
Li-Po Battery x 1
CW/ CCW Propellers x 4
CC3D Flight Controller x 1
Adapter Cable x 1
USB Cable x 1
Heat Shrink Tubing x 1
3M glue x 5
Nnylon Zip Ties x 20
Damping pipe x 4
Female Plug Connector x 12
Male Plug Connector x 12
Damping plate x 1(set)
Section Board x 1
Lashing x 1
Allen Wrench x 1
Velcro Tape x 1